This page (revision-23) was last changed on 2022-03-22 20:37 by Murray Altheim

This page was created on 2019-12-23 02:09 by unknown

Only authorized users are allowed to rename pages.

Only authorized users are allowed to delete pages.

Page revision history

Version Date Modified Size Author Changes ... Change note
23 2022-03-22 20:37 6 KB Murray Altheim to previous
22 2022-03-22 20:35 6 KB Murray Altheim to previous | to last
21 2021-12-23 09:02 4 KB Murray Altheim to previous | to last

Page References

Incoming links Outgoing links
Raspberry Pi
RaspberryPi

Version management

Difference between version and

At line 1 changed 4 lines
%%alias
Aliased from [Raspberry Pi 4]
%%
|[{Image src='attach/RaspberryPi/RaspberryPi3B%2B.jpg' width='250' caption='Raspberry Pi 4'}] | [{Image src='attach/RaspberryPi/RaspberryPi4.png' width='250' caption='Raspberry Pi 3 B+'}] | [{Image src='attach/RaspberryPi/RaspberryPiA%2B.jpg' width='250' caption='Raspberry Pi A+'}] | [{Image src='attach/RaspberryPi/RaspberryPiZeroW.jpg' width='250' caption='Raspberry Pi Zero W'}] | [{Image src='attach/RaspberryPiPico/pico-oblique-800x.jpg' link='https://service.robots.org.nz/wiki/Wiki.jsp?page=RaspberryPiPico' caption='Raspberry Pi Pico' width='150'}]
This page will eventually contain a whole lot of information about the __Raspberry Pi__.
At line 3 added one line
(Not quite yet)
At line 7 changed 4 lines
From the [Raspberry Pi|https://en.wikipedia.org/wiki/Raspberry_Pi] page on Wikipedia:
%%blockquote
The __Raspberry Pi__ is a series of small single-board computers developed in the United Kingdom by the Raspberry Pi Foundation to promote teaching of basic computer science in schools and in developing countries. The original model became far more popular than anticipated, selling outside its target market for uses such as robotics. It now is widely used even in research projects, such as for weather monitoring because of its low cost and portability. It does not include peripherals (such as keyboards and mice or cases. However, some accessories have been included in several official and unofficial bundles.
%%
The Raspberry Pi has several main interfaces, the 40 pin [GPIO], the 2 pin [I2C] and the [SPI] serial interfaces.
At line 12 removed 6 lines
The Raspberry Pi and Arduino both contain ''microprocessors'', the actual ''Central Processing Unit'' (CPU) integrated circuit chips that perform the execution of software code. The Raspberry Pi is a ''microcomputer'', whereas the [Arduino] is a ''microcontroller'' (%%(font-size:small) AKA%% ''Microcontroller Unit'' or MCU). The Raspberry Pi microcomputer has a full Linux-like operating system (OS); the Arduino generally runs a single program.
The distinctions between microprocessors and microcontrollers can get a bit blurry, since in practice they can often perform similar tasks. But you can think of a Raspberry Pi as almost the same as a desktop computer, without the peripherals. Indeed, [some people|https://magpi.raspberrypi.org/issues/85] have outfitted their Pis with keyboards, mice, large screen monitors, and use them for everyday computing tasks.
The Raspberry Pi has several interfaces, the 40 pin [GPIO], the 2 pin [I2C] and the [SPI] serial interfaces.
At line 20 removed one line
The [KR01] robot uses a Raspberry Pi 3 B+, the [KRZ01] robot uses a Raspberry Pi Zero W.
At line 22 removed 11 lines
! Power Supply
I'd say a sizeable majority of problems people have with Raspberry Pis are related to power supply. It's almost unfortunate that it ''can'' be powered by USB since that gives people the impression that plugging a Pi (often including additional peripherals) into a USB port, a USB power bank, etc. should just work. The Pi actually is meant to run at 5.1 volts, not 5.0 volts, and will stop operating and reset itself around 4.85v. So at 5 volts the Pi is already working under its optimal voltage, and not all USB power sources even provide 5 volts (some lower, some dangerously higher — fast chargers at 7 volts will immediately smoke test your Pi). Power supply voltages typically brown out (drop) under load, so pushing the power supply with a display, WiFi, a fan, etc. often leads to problems.
In terms of choosing a power supply it's good to overspecify by maybe 20% as you'll want a buffer. E.g., a *bare* Pi 4 B requires 3 amps (15 watts), a bare Pi 3 B+ 2.5A Overclocking would increase the requirement. Additional peripherals would also add to that value. You'll sometimes see "idle" power specified but that's rather useless for specifying power supplies unless your Pi will never do more than idle.
!! Pico
On the 21st of January, 2021, the Raspberry Pi Foundation released its own [microcontroller] board called the [Raspberry Pi Pico|RaspberryPiPico]. Despite any confusion created by its name it's a [microcontroller] rather than a [Single Board Computer] (SBC) like the Raspberry Pi, uses an [RP2040] CPU chipset (designed by the Raspberry Pi Foundation), and is significantly cheaper than any Pi at US$4.
At line 35 changed one line
See: [Raspberry Pi OS|RaspberryPiOperatingSystem]
* [Frequently-Asked Questions|https://www.raspberrypi.org/documentation/faqs/]
At line 37 removed 14 lines
* [Raspberry Pi|https://en.wikipedia.org/wiki/Raspberry_Pi] on Wikipedia
* From __raspberrypi.org__:
** [Raspberry Pi home page|https://www.raspberrypi.org/]
** [Frequently-Asked Questions|https://www.raspberrypi.org/documentation/faqs/]
** [Documentation|https://www.raspberrypi.org/documentation/]
* [Raspberry Pi® User Guide|https://dn.odroid.com/IoT/other_doc.pdf], posted by Odroid
* [Raspberry Pi Education Manual|https://downloads.raspberrypi.org/Raspberry_Pi_Education_Manual.pdf] (PDF)
** [Five Ways To Run a Program On Your Raspberry Pi At Startup|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/]\\ E.g.: ( [rc.local|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/#local] | [.bashrc|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/#bash] | [init.d tab|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/#init] | [systemd|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/#systemd] | [crontab|https://www.dexterindustries.com/howto/run-a-program-on-your-raspberry-pi-at-startup/#crontab] )
* [Make a Raspberry Pi 4 program start on boot|https://roboticsbackend.com/make-a-raspberry-pi-3-program-start-on-boot/], from ''[The Robotics Back-End|https://roboticsbackend.com/]''
* [How do I switch to a new desktop environment?|https://www.raspberrypi.org/forums/viewtopic.php?t=207647] (how to switch from LXDE to MATE or any other available desktop)
* [Using the Raspberry Pi Timer for Embedded Environments|https://www.studica.com/blog/raspberry-pi-timer-embedded-environments], basically writing assembly code to use the Pi's hardware timer
* [New Pi Zero Gains Unapproved Antennas Yet Again|https://hackaday.com/2021/12/13/new-pi-zero-gains-unapproved-antennas-yet-again/] on Hackaday
This page (revision-23) was last changed on 2022-03-22 20:37 by Murray AltheimTop