This is version 1 2 3 4 5 6 7 8 9 10 11 12 13 14 . It is not the current version, and thus it cannot be edited.

Back to current versionRestore this version

The ADS1015 is a +/- 24V Analog Digital Converter implemented by Pimoroni as a Breakout Garden board, i.e., an I2C compatible breakout board. TIt has three channels that can read voltages from -24V to +24V at sampling rates up to 3.3KHz with 12-bit resolution.

Features#

• 12-bit precision
• +/- 24V (DC) measurement range
• Three channels
• Programmable gain
• Up to 3.3KHz sampling rate
• I2C interface (address 0x48/0x49 (cut trace))
• 3.3V or 5V compatible
• Reverse polarity protection
• Compatible with all models of Raspberry Pi, and Arduino
• ads1015-python library on github
• ADS1015 ADC (original TI datasheet)

Installation#

You'll need Python and pip (or pip3 for Python 3) already installed.

If you're using Python 2, just run:

sudo pip install ads1015

For Python 3, use:

sudo pip3 install ads1015

Example Usage#

The board has three input pins, labeled A0, A1 and A2. Plugging a signal into A0, here's an example of some code to repeatedly read the voltage on the pin until you type Ctrl-C:

    #!/usr/bin/env python3
    import time      
    from ads1015 import ADS1015
    
    print('''read-all.py - read the A0 input of the ADC.
    
    Press Ctrl+C to exit!
    ''')
     
    CHANNEL = 'in0/ref'
    ads1015 = ADS1015()
    ads1015.set_mode('single')
    ads1015.set_programmable_gain(2.048)
    ads1015.set_sample_rate(1600)
     
    reference = ads1015.get_reference_voltage()
    print("Reference voltage: {:6.3f}v \n".format(reference))
    
    try:
        while True:
            value = ads1015.get_compensated_voltage(channel=CHANNEL, reference_voltage=reference)
            print("A0 value: {:6.3f}v".format(value))
            time.sleep(0.5)
    
    except KeyboardInterrupt:
        pass

References#

• !!! ADS1015 +/-24V ADC breakout product page

---