This page (revision-6) was last changed on 2021-03-20 03:45 by Murray Altheim

This page was created on 2021-03-19 22:00 by Murray Altheim

Only authorized users are allowed to rename pages.

Only authorized users are allowed to delete pages.

Page revision history

Version Date Modified Size Author Changes ... Change note
6 2021-03-20 03:45 3 KB Murray Altheim to previous
5 2021-03-19 22:19 3 KB Murray Altheim to previous | to last
4 2021-03-19 22:15 2 KB Murray Altheim to previous | to last
3 2021-03-19 22:07 2 KB Murray Altheim to previous | to last
2 2021-03-19 22:02 2 KB Murray Altheim to previous | to last
1 2021-03-19 22:00 2 KB Murray Altheim to last

Page References

Incoming links Outgoing links
Orange Pi...nobody
OrangePi

Version management

Difference between version and

At line 22 changed one line
Note that the I2C 1 bus SDA and SCL pins do not reside on pins 3 and 5 like a Raspberry Pi, and so far despite there being multiple active buses (0, 1, 3, 4 and 7), I've been unable to get __any__ I2C device to show up using i2cdetect. Therefore, until there is some resolution of this issue, the Orange Pi is not considered suitable for robotics use. While it is a higher performance board than the [Raspberry Pi 4], it also runs very hot, with a power consumption of over 4 watts when fully loaded, whereas the Raspberry Pi 4 is rated 2.85w, the Pi 3 B+ at 2.5w. Testing on various websites indicates its actual power usage is probably closer to the Pi 4 when not using the neural processor of the Orange Pi 4B.
! Compatibility with Raspberry Pi
At line 24 added one line
Note that the I2C 1 bus SDA and SCL pins do not reside on pins 3 and 5 like a Raspberry Pi, and so far despite there being multiple active buses (0, 1, 3, 4 and 7), I've been unable to get __any__ I2C device to show up using i2cdetect. Therefore, until there is some resolution of this issue, the Orange Pi is not considered suitable for robotics use — at least with Raspberry Pi accessories.
At line 26 added 3 lines
While it is a higher performance board than the [Raspberry Pi 4], it also runs very hot (at times upwards of 80°C), with a power consumption of over 4 watts when fully loaded, whereas the Raspberry Pi 4 is rated 2.85w, the Pi 3 B+ at 2.5w. Testing on various websites indicates its actual power usage is probably closer to the Pi 4 when not under load, and in the case of the Orange Pi 4B, not using the NPU (Neural Processing Unit).
This page (revision-6) was last changed on 2021-03-20 03:45 by Murray AltheimTop